Looks good. Did you scale everything 50% with smaller bearings, smaller screws, and smaller arbors?
The drive weight might need to be a different scale. 50% in all directions would only weigh 1/8 as much, which likely is not enough to keep the clock running.
The pendulum length will need to be the same length as the original design to run at the same rate. You can add several additional center sections until it is long enough.
Yes and all 50%, the bearings are made of nyilon, I just have to tune the weight and the pendulum
Looks good. Did you scale everything 50% with smaller bearings, smaller screws, and smaller arbors?
The drive weight might need to be a different scale. 50% in all directions would only weigh 1/8 as much, which likely is not enough to keep the clock running.
The pendulum length will need to be the same length as the original design to run at the same rate. You can add several additional center sections until it is long enough.
Steve