Steve,I have a qidi plus 2 printer with a print bed of 270 mm x 200mm. Is there any way I could print the moon clock on my printer?Looking forward to your response ( hope it's yes )ThanksAlan
Steve
After a lot of fiddling around I got the full size diameter 8 inches to fit and print.
see attached.
Steps taken:
1 down loaded Cura
2 set plate size to 209mm x270mm x 200mm
3 adjustment to limit mico switch (see photo) moved back by 6mm
4 moved build plate back by 6mm
all printed fine.
The print in progress if for the dial. All should be fine now.
Many Thanks for your help and advise.