I am wanting to print this clock on my Markforged Onyx printer; however the dial is too wide. If I can get two STLs of the dial split across a diameter that would make it possible to print both and join. I could do this myself if I had the SW part file, or could generate them if I had a dimensioned drawing. None of the online STL editors seem to support dividing a file in two or deleting half.
top of page
bottom of page
Is that printer a 320x132x154mm filament printer?
Normally, I recommend never splitting the dial, but the dial on this clock has nothing along the sides. Can you simply cut away the left and right sides of the dial and glue them back on after printing? PrusaSlicer allows this edit.