Ciao Steve,
scusa ma ho un pò di domande da farti e di incertezze:
ho provato a sostituire il filo armonico da 1,5 mm, il problema che ho riscontrato è che il filo armonico non è perfettamente diritto al 100% e è quasi impossibile a bilanciare correttamente il cricchetto, questa è una mia opinione, ti allego il primo video dove si nota un certo sbilanciamento con filo nuovo, ho provato stampare anche l'ingranaggio senza viti ma è uguale all'altro c'è sempre un punto dove è sbilanciato.
Il problema che avevo l'altro giorno e che ti ho fatto vedere tramite un video , non c'è l'ho più, cioè il cricchetto che aumentava a un certo punto i passi.
Tramite il secondo video ti vorrei fare vedere la lancetta dei secondi che in alcune posizioni quando scatta torna leggermente indietro, penso a causa del minimo sbilanciamento che ha il cricchetto, ti volevo chiedere se è una cosa normale o se è un problema, e se secondo te i passi della lancetta vanno abbastanza bene.
Ho controllato con un cronometro e la lancetta dei secondi fa un giro completo in 59,36 secondi non in 60 secondi, per portare il giro completo a 60 secondi cosa dovrei fare ?.
Nel terzo video ti vorrei fare vedere i cricchetti, secondo me ho trovato la coppia corretta del cricchetto statico e dinamico, vorrei gentilmente un tuo parere, ma ti volevo fare notare anche il cricchetto statico che quando si mette in posizione a volte ritorna indietro andando a sbattere in contro il dente dell'ingranaggio e in posizioni diverse ci rimane circa 2/3 mm tra il dente dell'ingranaggio e il cricchetto statico, secondo me è dovuto sempre al cricchetto non bilanciato al 100%, tutto questo Steve secondo te è normale ?.
Grazie mille per la gentilezza e la professionalità e servizio che stai dando.
Hi Steve, I reconnect to the messages I sent you some time ago, for the electromagnetic clock, it's been a while since I've been trying this watch, 4/5 months, but I can't get it to work properly, as you can see from the video, the hand of the seconds it makes full turns and sometimes it stops because the ratchet fails to pass on the other tooth, in practice the clock stops and does not go forward, then it resumes rotation, I tried to do all the configurations of the ratchets but in the end either that I make things worse or that the same problem always remains. I do not understand what it could be, if the second hand which is not perfectly balanced, (but I printed it with the parameters you gave me), or if the gear where the two ratchets slide is ovalized and then arriving in a some point it stops, I want to clarify that the point where it stops is almost always the same, a few times it stops at another point of the gear. In your opinion what could it be?, Do you have any advice for me?. A thousand thanks. Good day. Maximilian. content_copy share